When there is a strong wind, the door may be thrown around. It will not only cause loud noises, cause trouble to us, but also damage the door. In order to avoid this, we need to install a door stopper. What Is it the door stopper? As the name implies, it is a product that can hold the door and fix it. With the door stopper, we don’t have to worry about the door closing and closing by itself, and we don’t have to worry about the door being damaged. Then, how about the installation of the door stopper product? Let’s get to know it together.

Determine the installation design of the Zinc Alloy Door Stops with rubber

Before installing the door stopper, we need to install the door stopper, that is to say, do we install the door stopper on the ground? Or install it on the wall? After determining the installation position of the door stopper, let’s make a measurement and thinking about the installation size of the door stopper, the space behind the door, the largest position, etc. that need to be reserved. After locating these roughly, we can consider the installation of the door stopper in the next step.

Start the installation of the door stopper

Now we can install the door stopper. First, drill the ground drill, that is, drill the mounting hole of the door stopper on the ground, then fix the door stopper and tighten the screws on the door stopper. This tightening of the door stopper requires Careful, because if the screws are not fixed well, then the installation of the door stopper cannot be regarded as successful. After the assembly of the door stopper is completed, it can be regarded as the completion of the installation of the door stopper, as long as there are no errors in the installation steps. If this is the case, the use effect of the door stopper will also be very good. Overall, the installation of the door stopper is relatively simple.

Finally, adjust the door stopper

After the door stopper is installed, we will make a final adjustment to the door stopper, because the angle of the door stopper can be wrong, and it cannot fit the door perfectly, so we need to carry out the adjustment according to the specific angle. A simple fine-tuning can make the door stopper fit the door completely, so that the effect of the door stopper will be better.