Determine whether the stainless steel Door Stops SS visible is installed on the wall or the floor (according to the actual situation). Test and determine the position of the door stopper. Open the door to the maximum position, initially determine the position of the door stopper, open the door, adjust the position of the door stopper, and use the method of fine-tuning up, down, left, and right until the proper position and angle are reached. In the final test, open the door to its maximum and determine its position.

If it is installed on the ground, it should be limited to the fixed position of the door, and then make a final confirmation on the opposite side and make a mark. Draw a line to confirm that the door is opened to the largest position. Finally, determine the installation position of the door stopper. Draw the position of the door stopper. According to the above test, it is best to locate the position of the door stopper twice, which is mainly for easy installation. Also in order to better confirm the angle of the door suction and opening.

Use a drill to drill at the position where the door stopper is installed. For example, drill the installation hole of the door stopper on the ground. Assembly of the fixed end of the door stopper. Install the fixed end of the door stopper and screw on the screws.

Fix the door stopper on the ground (this step requires professional experience). Use a small inner angle to screw the screw. After reconfirming the position, drilling and assembly procedures, the next step is to install the fixed end on the ground. Use the included inner angle. Tighten the screw on the fixed end with the small tool, and the door stopper is automatically installed. Determination of the position of the door stopper on the door. The door stopper end on the door only needs to be screwed tightly. After both ends of the door stopper are installed, it should be almost the same. The most important thing is to test, open the door until it is drunk, and then find the position of the door stopper on the door. Screw the door stopper on the door end.

Fine-tuning. In the last step, the angle of the revolving door stopper is fine-tuned to make it all fit the door stopper, and finally the screw is completely tightened.