Door suction installation method introduction one

1. First, confirm with the owner whether the Stainless Steel 201 ball magnet Door Stopper is installed on the ground or on the wall. Because this is a bathroom, the owner decided to install the door stopper directly on the floor tiles, leaving space behind the door.

2. In the second step, open the door to the required maximum position, test whether the suction effect of the door is reasonable, and whether the distance of the door suction on the door is appropriate to locate the position of the door. After roughly positioning, open the door and try whether the actual operation is reasonable, including Does the door stopper go in a little bit or come out a little bit? What is the specific angle of the door stopper.

3. After the final position is determined, do positioning on the ground and floor tiles, and first locate the stopping position of the door

Use a pencil to confirm the position of the door on the floor tiles, and the worker master uses a pencil to draw a line on the ground, first confirm the last position of the door open, and the next step is to confirm the final installation position of the door stopper

4. After the door is positioned, draw the position of the door stopper

The worker master is marking the last position of the door stopper. The reason why it is necessary to position it twice is to position the door and the door stopper. This is for better installation. This is the best way to confirm the angle of the suction and opening of the door.

5. The next job is to drill an electric drill and drill the installation of the door stopper on the ground

6. Assemble the fixed end of the door stopper

The fixed end of the door stopper is being installed. Tighten the screws above. The door stopper is divided into a fixed end and a door end. On the wall.

7. The fixed door is sucked on the ground

Tighten the screw with a small inner angle. This is a fine job. No experience is enough. After confirming the position, punching, and assembling, the next job is to install the fixed end on the ground, and tighten it with the included inner angle tool. Fix the screws on the end, and the door stopper will be installed automatically.

8. Confirm the position of the door stopper at the door end

The door suction end on the door only needs to be tightened with screws. The fixed end of the door absorber is still useless after installing the light. The key point is the positioning of the door end. Use screws to tighten the door stopper on the door at the exact position.